VPI Scoutmaster JMW-9T Manuál s instrukcemi

Scout 2/JMW-9T Turntable Manual Setup and Instruction Manual VPI Industries, Inc., 77 Cliffwood Ave. #3B, Cliffwood, NJ 07721 phone: 732-583

7 Additional Items Available from Your Dealer • The VPI Synchronous Drive System power supply provides a major increase in musicality by feeding the

Important: Read Before Proceeding!  Read and follow the Safety Instructions below.  Save all packing materials. The Scout should only be moved or

Introduction The Scout turntable is a precision instrument featuring the new Tapered arm tube version of the JMW-9 tonearm. It has been thoroughly te

1 Unpacking the Box The turntable and tonearm are packed very carefully to avoid damage during shipping. It is important that you save the packing mat

2 4. Lift the chassis and place it over the power cord. The motor should extend approximately .25 inch from the side of the turntable chassis. 5. Pl

3 • Using tweezers or fine-tipped pliers, grip the center of the red wire’s connector  not the wire itself  and push it onto the cartridge’s right

4 Setting the Anti-Skating – Two Solutions Anti-skating is one of the least understood forces acting on a tonearm. Skating force is created by fricti

5 turn the adjustment wheel above the base. When the arm is at the desired height, tighten the screws. • If you do not raise the arm when doing this

6 Playing Records Before playing a record, make sure that all of the tonearm screws are tight. Place the black washer on the platter, then the reco