VPI Scout 2/JMW-9T Manuál s instrukcemi

Scout 2/JMW-9T Turntable Setup and Instruction Manual VPI Industries, Inc., 77 Cliffwood Ave. #3B, Cliffwood,

7 E. ARM HEIGHT:  Place a record on the turntable. Loosen the two setscrews in the base of the arm (right side and rear of base). Lower the a

8 Additional Items Available from Your Dealer  The VPI Synchronous Drive System power supply provides a major increase in musicality by feeding th

9 VPI Industries, Inc. Limited Warranty VPI Industries, Inc. (VPI) warrants this unit against defects in materials and/or workmanship for three (3)

Important: Read Before Proceeding!  Read and follow the Safety Instructions below.  Save all packing materials. The Scout 2 should only be moved o

Introduction The Scout 2 turntable is a precision instrument featuring the new Tapered arm tube version of the JMW-9 tonearm. It has been thoroughly t

1 UNPACKING THE BOX The turntable and tonearm are packed very carefully to avoid damage during shipping. It is important that you save the packing mat

2 7. Verify the turntable is level by using a 9- or 12-inch bubble level front-to-back and side-to-side on the platter. If it is not level, rotate th

3 B. OVERHANG ADJUSTMENT:  This adjustment will yield the lowest distortion in the last third of the record, the hardest to track, when playing a

4  Double check the adjustments made above. The cartridge needs to be both centered and "square" between the gird lines and

5  The JMW-9T does not have a built-in tracking force gauge, but a Shure Stylus Force Gauge is supplied with your arm on a new unit. Following the

6 D. ANTI-SKATING:  Anti-skating is one of the least understood forces acting on a tonearm. Skating force is created by friction b